15
309377
Troubleshooting
Error Codes
Error codes are listed below. Even in an error condi-
tion, the unit keeps track of the amount dispensed.
With any error code displayed, as shown at right, you
can
D
Press the Manual/Reset button.
Error code is cleared, unit switches into Manual
mode, and dispensed amount is displayed.
D
Press the Auto/Reset button.
Error code is cleared, unit switches into Auto mode,
and the preset amount is displayed.
06044A
! CAUTION
To prevent overfills and spills
Maximum Working Pressure 7 MPa (70 bar, 1000 PSI)
D
Do not obstruct the trigger
D
Do not leave unattended
D
Do not operate below 32
_
F (0
_
C)
D
Read instruction manual
Error Code
Cause
Solution
Err 1
Flow rate is higher than 5 gpm.
or
Air was pumped through the line.
Adjust the flow rate so it is not higher
than 5 gpm.
Purge air from the line.
Err 2
Switch Error: Error occurred with
pick-up in internal gear.
or
Unit was dropped or unit encoun-
tered excessive vibration during
shipping.
Ensure that your flow rate is not
higher than 5 gpm. For further assis-
tance, contact your Graco distributor.
Press the Manual/Reset button at
start-up.
Err 4
Flow has continued after it should
have shut off.
Check if the unit is resting on the
trigger or if an obstruction is pressing
the trigger. The unit checks for flow
every two seconds, and it beeps and
repeats the error code until the
trigger is released and the error code
cleared.
Err 5
The unit has dispensed the shut-off
default amount and has stopped
fluid flow.
Press the Manual/Reset button, and
dispense again. To change the
shut-off default amount, see the
Shut-off Default Amount section
on page 10.
Err 6
A preset dispense amount of zero
was entered for the dispense or is
stored as the default, and a Preset
dispense was attempted.
Enter an amount that is not zero.
See the Auto Preset Amount
section on page 9.
