Graco LSR Select, Инструкция по эксплуатации

Страница: 95 / 112

Appendix A - HMI Screens Overview
3A2152B 95
1. BASE/INHIBITOR/CATALYST/COLOR/MIXED Cur-
rent Pressure (PSI) readout: This is the actual
pressure in the pumps. If the pump is in the reload
position, the readout shows the pressure of the
material being pumped into the pump. If the pump is
dispensing, the readout shows the pressure of the
material being pumped to the stack. The MIXED
pressure reading is the value between the mixer
outlet and the inlet to the screw.
2. BASE/INHIBITOR/CATALYST/COLOR/MIXED high
limit: This is the pressure that will shut the machine
down if reached.
3. BASE/INHIBITOR/CATALYST/COLOR/MIXED low
limit: This is the pressure that will shut the machine
down if the pressure dips below. This is useful to
shut down the system is a pump runs out of material
and the component isn't being added to the mix. To
ignore the low level, enter zero.
4. ENABLE/DISABLE PRESSURE SHUTDOWN push
buttons and indicator. Push the Enable Pressure
Shutdown button to enable the shutdown on a pres-
sure fault.
NOTE: This is the default value. The indicator below the
push buttons will read “ENABLED”. To disable the shut-
down, push the Disable Pressure Shutdown button. It is
recommended to leave this feature enabled. Check to
see if it only looks at the low when dispensing.
5. ENABLE/DISABLE PRESSURE ALARM push but-
tons and indicator. Push the Enable Pressure Alarm
button to enable the alarm on a pressure fault.
NOTE: This is the default value. The indicator below the
push buttons will read “ENABLED”. To disable the
alarm, push the Disable Pressure Alarm button. It is rec-
ommended to leave this feature enabled. This is used to
keep running on a pressure fault, however the user will
get an alarm signal that the pressure went over or under
the specified values. When the pressure shut down is
enabled, the alarm is also enabled.
6. CLEAR PRESSURE FAULT push button. In the
event of a pressure shutdown fault, the system will
not run again until the pressure is brought into the
limits and the Clear Pressure Fault push button is
pressed.