Startup
3A9034B
9
Incline/ECO Mode
Incline/ECO Mode is the recommended default mode
for all operations. It is helpful when greater control is
needed such as during loading or unloading and in
congested areas. Incline/ECO mode should be used
when operating on inclines. It also extends battery life.
To enable Incline/ECO mode:
• Set Speed Switch to Incline/ECO
position.
NOTE:
Incline/ECO Mode limits forward speed to 5.5
mph (9 kph) and reverse speed to 4 mph (6 kph).
To disable Incline/ECO Mode:
• Return Speed Switch to center position.
Buzzer
A buzzer will sound to indicate different operating
conditions.
Daily Inspections
Perform the following inspections each day before
using the LineDriver ES Lithium.
1. Check battery charge level. Charge if not fully
charged.
2. Inspect Coupler for excess movement. Adjust if
needed. See
Replace Coupler when it is no longer adjustable.
3. Check function of the Seat Interlock Switch. The
Seat Interlock Switch stops the ES Driver when the
operator leaves the seat, and disables the
Direction/Speed Pedals.
a. With the Parking/Emergency Brake ON, move
the Power Switch to the ON position while
standing next to the LineDriver ES.
b. Gently tap the Direction/Speed Pedals. The
LineDriver ES should not attempt to travel.
c. Sit on the seat and gently tap the
Direction/Speed Pedals. The unit should
attempt to travel.
d. Service the Seat Interlock Switch if the
LineDriver does not respond as described in
steps b and c above.
4. Test Parking/Emergency Brake function and
adjustment.
a. Choose a flat open area. Accelerate unit to 3
mph (5 kph).
b. Cause the LineDriver ES to roll freely
(freewheel) by moving the Power Switch to the
OFF position.
c. Stop unit by applying Parking/Emergency
Brake. To adjust brakes, see
Parking/Emergency Brake Adjustment or
Single tone, about one
second long, after
turning the Power Switch
ON.
Direction/Speed control
pedals now active.
Repeating tone, about
every second.
Batteries are deeply
Continuous tone while
traveling faster than 6.5
mph (10 kph).
Reduced braking available
from Direction/Speed
Содержание LineDriver 25U670
