Graco LineDriver 25U670, Операция - Ремонт - Запчасти

Страница: 10 / 40

Operation
10 3A9034B
Operation
Differences in Operation
The LineDriver ES Lithium operates differently than a
gasoline powered LineDriver.
1. LineDriver ES rolls freely, especially on inclines,
when the power is off. Set Parking/Emergency
Brake before turning off.
2. Turn power on before releasing Parking/Emergency
Brake.
3. Performance drops when the battery charge
becomes low. When there is about one hour of
runtime remaining, the Voltage Meter begins to
flash. When the batteries are deeply discharged
and the LineDriver ES is about to shut down, the
buzzer sounds about once per second.
4. The response of the Direction/Speed pedals is
softer. Learn this softer response before operating
on a job site.
How to Operate
1. Sit on seat to actuate Seat Interlock Switch. Ensure
Direction/Speed Pedals are not depressed.
2. Turn Power Switch ON. Buzzer will sound in a few
seconds, indicating that the Direction/Speed
Pedals are now active.
3. Disengage Parking/Emergency Brake on LineDriver
and any brakes on attached equipment.
4. Squeeze hand control to release caster wheel of
attached equipment.
NOTE: LineDriver motion is forward and reverse. Turns
are made with the striper or grinder.
5. Push striper or grinder handle bars to begin desired
turn.
6. Move Direction/Speed pedals to drive the
LineDriver, as shown below. Switching from
forward to reverse creates a braking action.
NOTE: LineDriver stops when both feet are removed
from pedals.
ti10937a
FREEWHEEL HAZARD
Turning the Power Switch OFF will result in loss of
drive power. Loss of drive power causes LineDriver to
freewheel, which allows it to roll freely.
• Do not turn Power Switch OFF while LineDriver is
in motion.
• If loss of drive power occurs while LineDriver is in
motion, use the Parking/Emergency Brake to bring
LineDriver to a stop.
• Always engage Parking/Emergency Brake before
turning Power Switch OFF or standing up from
seat.
ti10935a