Graco InvisiPac GS35 Plug-Free, Инструкция - Каталог запасных частей

Страница: 12 / 34

Maintenance
Maintenance
Material inside the applicator can be near setpoint
temperature. Wear protective clothing to avoid
severe burns.
Daily:
Clean hot melt and char from exterior of gun.
Weekly:
Inspect the applicator, fluid lines, cordset,
and solenoid cable for wear or damage. See
Repair, page 17 for instructions.
Replace Inlet Filter
NOTICE
Remove the filter when the gun is hot. If the gun is
cold, the adhesive will be hard and the filter may
be difficult to remove or damaged.
1. Disable gun assembly. See
Before Beginning Repair, page 17 .
Material inside the applicator can be near
setpoint temperature. Wear protective clothing
to avoid severe burns.
2. Remove dirty filter (16) from manifold (1).
16
1
Figure 9 Inlet Filter
3. Apply a thin coating of high-temperature lubricant
to seals on the new filter (16) and install in the
manifold (1). Torque to 30 in-lbs (3.4 N∙m),
usings a 5/32 in. (4 mm) Allen wrench.
12 3A2805B