6. Air tankis supplied with a 3/8 NPT female adaptor
on the incoming air on the side of the tank. Use
fittings supplied to attach your compressed air
source to the tank. Place air tank either near the
InvisiPac or by the feed container. Run a section
of 3/8 in tubing from the air tankto the air inlet of
the InvisiPac.
Note
All air tubing used on feed container and
tankis 3/8 inch OD (1/4 ID) tubing.
Figure 5
7. Run GRAY air tube from air tankto feed
container. Connect to the fitting (F). See
.
Figure 6
8. Use without tank. Run a 3/8 diameter TUBE to
the fitting on the outside of the feed container
(F). See
.
9. Lift and rotate the lid to fill container with hot melt
adhesive.
Figure 7
10. Turn on InvisiPac and open air supply ball valve
to unit. Checkall fittings to ensure there are no
air leaks around air tubing. Adjust the Advanced
Feed System (AFS) Assist Air pressure on the
front of the InvisiPac according to the table below.
Note
Use the lowest pressure first and
increase pressure as required to achieve
error-free feeding.
Recommended Air Pressure Ranges
psi (kPa, bar)
Spherical
Pellet
Round or
Rectangular
Tablet
InvisiPac Feed
Air
60–80
(420–550,
4.2–5.5)
60–100
(420–690,
4.2–7)
AFS Assist Air
Pressure
15–100
(103–690, 1–7)
80–100 psi
(550–690,
5.5–7)
11. Allow InvisiPac to warm up and then resume
production. Refer to operation manual for
InvisiPac for further instructions.
6
334629A
