Replace Seals or Rebuild Air Valve
Follow these instructions to service the air valve with
one of the available repair kits. Air Valve Seal Kit
parts are marked with a †. Air Valve Repair Kit parts
are marked with a ♦. Air Valve End Cap Kit parts
are marked with a ‡.
Disassemble the Air Valve
1. Perform steps 1-3 under
Replace Complete Air Valve, page 11
.
2. Use a T10 Torx screwdriver to remove two
screws (209). Remove the valve plate (205) and
cup assembly (212-214).
3. Pull the cup (213) off of the base (212). Remove
the o-ring (214) from the cup.
4. Remove the retaining ring (210) from each end
of the air valve. Use the piston (202) to push
the end cap (207) out of one end. Remove the
u-cup seal (208) from the piston. Pull the piston
out of the end and remove the other u-cup seal
(208). Remove the other end cap (207) and the
end cap o-rings (206).
Reassemble the Air Valve
NOTE: Apply lithium-based grease when instructed
to grease. Order Graco PN 111920.
1. Use all parts in the repair kits. Clean other parts
and inspect for damage. Replace as needed.
2. Grease the u-cups (208♦†) and install on the
piston with lips facing toward the center of the
piston.
Lips face
down.
Lips face
up.
3. Grease both ends of the piston (202♦) and the
housing bore. Install the piston in the housing
(201), with the flat side toward the cup (213♦).
Be careful not to tear u-cups (208♦†) when
sliding piston into housing.
4. Grease new o-rings (206♦†‡) and install on the
end caps (207‡). Install the end caps into the
housing.
5. Install a retaining ring (210‡) on each end to hold
end caps in place.
12
3A2714B
Содержание Husky 2200
Страница 10: ...Notes Notes 10 3A2714B ...
Страница 20: ...Parts Parts 20 3A2714B ...