Graco 25E202, Инструкция по эксплуатации

Страница: 20 / 46

Installation
20 3A6931A
3. See
Figure 31
on page
19
and remove the pump
coupling, pump lower, and three tie rods from the air
motor supply system. Save these parts to be used
when installing the kit. Refer to the Supply Systems
Operation manual and the Supply Systems
Repair-Parts manual. See
Related Manuals
on
page
2
.
4. Remove the air motor supply hose and fittings from
the top of the air controls.
5. On the air controls, disconnect the air motor shutoff
and control sections together by removing the two
screws underneath the air motor control as shown in
Figure 31
on page
19
. Lift the two sections to
remove them. Remove the o-ring from around the
hole in the top of the air controls.
6. Remove the air motor from the ram.
Assemble the Electric D200s Ram
Conversion Kit
NOTE:
Refer to the
Air to Electric D200s Ram
Conversion Kit, 25P286-88
parts on page
38
for
correct assembly.
1. Refer to
Figure 32
and remove the hex nut from the
ram’s cross beam. Place the cable track bracket
(311) on the cross beam with the track on the rear of
the beam and replace the hex nut.
2. Attach the ram junction box (308) to the ram using
three screws (310) and washers (309) as shown in
Figure 33
.
3. Disconnect the wires from the disconnect block (A).
4. Remove and discard the driver junction box cover
(C) and the disconnect switch (B) from the driver.
See
Figure 34
.
5. Remove and discard the extrusion (D), then remove
and discard the plug (E).
6. Remove the cord grip and save it for reuse.
7. Install the electric driver (301) using the same
hardware that was used with the air motor.
8. Install the cord grip that was removed in step 6 in
the driver junction box where the plug was removed.
See
Figure 35
on page
21
.
All electrical wiring must be done by a qualified elec-
trician and comply with all local codes and regula-
tions.
F
IG
. 32: D200s Cable Track Installation
Hex Nut
311
F
IG
. 33: D200s Ram Junction Box Installation
F
IG
. 34: Remove Driver Junction Box
309,310
A
D
C
B
E
Cord Grip