Graco 25E202, Инструкция по эксплуатации

Страница: 21 / 46

Installation
3A6931A 21
9. The power cable from the ram junction box (308) is
routed through the cable track. Run it through the
cord grip and connect it using the supplied
connectors. Connect the ground wire to one of the
two green ground terminals inside the driver
junction box.
10. Install the new driver junction box cover using the
four screws. The cover and screws are included with
the cable track assembly.
11. Connect the cable track connections as shown in
Figure 36
.
a. Connect the two CAN connectors to ports 1 and
2.
b. Connect the 5 pin connector to port 3.
c. Connect the 8 pin connector to port 4.
NOTE:
Use
Figure 3
on page
10
for further reference.
12. Use the shaft adapter included in the kit and
connect the electric driver to the pump coupling,
pump lower, and tie rods that were removed from
the air motor pump. Refer to the E-Flo SP Supply
Systems Installation-Parts manual. See
Related
Manuals
on page
2
.
13. Connect the outlet check valve (302) using the
adapter fitting (304) included in the kit. Apply thread
sealant to the threads of the check valve and the
adapter fitting prior to installation. See
Figure 37
.
14. The pressure transducer cable from the outlet check
valve plugs into port 6 on the electric driver. See
Figure 3
on page
10
for reference.
15. Use the wire ties (303) included in the kit to secure
the pressure transducer cable to a tie rod.
16. Mount the assembled ADM mounting bracket with
four screws (310) and washers (309) as shown in
Figure 38
.
17. Plug the air line hole in the top of the air controls
with the supplied plug (134) as shown in
Figure 38
.
F
IG
. 35: D200s Driver Junction Box Cover
F
IG
. 36: D200s Cable Track Connections
Cord Grip
Cover
Screws
F
IG
. 37: D200s Outlet Check Valve Installation
F
IG
. 38: D200s ADM Mounting Bracket
302
304
325
309,310