Repair
333233D
17
Installation
1.
Install the new cover gasket (included in the elec-
tronics cover kit). See F
2.
Reconnect all wires.
3.
Install electronics cover (50) and tighten 12 screws
(20). Torque to 15-20 ft-lb (20-27 N•m). See F
page 16.
4.
Install new junction box gasket.
5.
Route fan cable through fan cord grip.
6.
Connect the stripped fan wire to the motor wire and
crimp the wires together.
7.
Connect fan ground wire. See F
See F
8.
Use an adjustable wrench to tighten the fan cord
grip (C1). See F
9.
Install gasket (52), junction box sleeve (S), and
tighten four bolts (56). See F
10. Install junction box cover (G) and tighten two screws
(6). See F
11. Install wires into disconnect switch (51) and tighten
wire screws.
NOTE:
The lower must be removed from the system
in order to calibrate correctly. The calibration stroke
length is longer than the operating stroke. Leaving
the lower attached will cause the driver rod to con-
tact the lower rod and it will not calibrate correctly.
12. Connect power cord.
13. Engage power.
NOTICE
If wires get pinched when the cover screws are tight-
ened, damage will occur. Make sure all wires are posi-
tioned inside the cover before installation.
F
IG
. 26: Install Fan Wires
WLD
/
/
/
7
7
7
