Repair
16
333233D
11. Remove 12 screws (20) and washers from electron-
ics cover (50).
12. Carefully tilt electronics cover (50) down.
13. Pull wire connectors down, out of the harness clip
and disconnect the motor power and motor tem-
perature wires (M).
14. Disconnect the stroke position sensor wire (H).
15. Disconnect the encoder wire (E).
16. Discard the used cover gasket (53) and the junction
box gasket (52).
F
IG
. 20: Electronics Cover Removal
F
IG
. 21: Tilt Electronics Cover
NOTICE
All wires must be disconnected before the cover is
completely removed. Hold the cover in place while
disconnecting wires or let the cover rest on a work
surface to avoid damaging the wires and connections.
F
IG
. 22: Motor Wires
WLD
50
20
WLD
50
M
F
IG
. 23: Stroke Position Wire
F
IG
. 24: Encoder Wire
F
IG
. 25: Electronics Cover and Junction Box Gaskets
WLD
H
WLD
E
WLD
53
52
