![background image](http://html1.mh-extra.com/html/graco/24t918/24t918_instruction-manual_2252663021.webp)
Setup
333347F
21
d.
Repeat for any additional applicators.
16.
If necessary,
set up the pattern controller (not
included) to control opening and closing of the appli-
cator. See pattern controller manual.
NOTE:
The system controls applicator heating only. A
separate pattern controller must be set up to open and
close the applicator.
17. Install the supplied air inlet bleeding ball valve and
air filter kit (Graco Part No. 24R707) at the 1/4 NPT
female system air inlet (J). See F
NOTE:
Elbows and riser tube provided with inlet air kit
are optional and may be used as desired.
NOTE:
The system must have a bleed-type ball valve
that bleeds pressure downstream when closed. Other-
wise, the supplied air will need to be disconnected from
the system whenever the pressure is relieved.
NOTE:
The system must use an air filter with a mini-
mum flow rate of 30 scfm.
18.
If using the same air for the applicator(s),
make sure
to install the tee in the air line before the ball valve.
There should not be anything between the ball valve
and the system. See
applicator
manual for
applica-
tor
air pressure requirements, and use a regulator
before the gun to decrease the air pressure, if nec-
essary.
19. Close the ball valve.
20. Attach a 3/8 in. minimum air supply line to air filter.
See F
. 13.
NOTE:
Air supply pressure must be between 80 psi
(550 kPa, 5.5 bar) and 100 psi (690 kPa, 6.9 bar). Rec-
ommended pressure is 100 psi (690 kPa, 6.9 bar). If air
pressure is expected to drop below 80 psi (0.5 MPa,
5 bar), there is an air reservoir kit that allows the system
to operate down to 60 psi (0.4 MPa, 4 bar). See
, on page 107.
21.
To lock access to the air pressure adjustments,
pur-
chase
. See installa-
tion instructions on page 101.
22.
To install a light tower that illuminates red when a
system error occurs,
purchase
. See installation instructions on page 106.
23.
To upgrade a 2 channel system to a 4 channel sys-
tem,
purchase
See installation instructions on page 108.
24.
To upgrade a 4 channel system to a 6 channel sys-
tem,
purchase
See installation instructions on page 110.
25. Install MZLP electrical connector caps on all unused
channels.
F
IG
. 12
WLE
J
F
IG
. 13
WLE
Содержание 24T918
Страница 16: ...Component Identification 16 333347F ...
Страница 103: ...Accessories 333347F 103 ...
Страница 129: ...Technical Data 333347F 129 ...