Graco 24M510, Инструкции по сборке, установке и эксплуатации

Страница: 8 / 34

Installation
8 3A2592A
Installation
General Installation Information
NOTE: Cord reels perform best when arm allows the
accessory cord to pull straight off the spool as shown in
F
IG
. 2.
NOTE: Always use 4 large flat washers with 4 bolts to
mount the reel base to any surface.
All Models
Select the reel bank mounting location.
• For high ceilings, suspend a suitable support
structure for the reels, so the accessory cords
will be long enough to reach your service area.
1. Select a location to mount the cord reel.
2. If cord reel has been previously installed, disconnect
cord reel from power source by unplugging power
cord from outlet.
3. Determine the desired position of the roller support
arm (a) (F
IG
. 3).
• The cord reel is factory-assembled and shipped
with the roller support arm (a) in position AA*
(F
IG
. 3). If that position is desired, skip step 4.
4. To reposition roller support arm to any other position
than the Ship Position (AA):
a. Secure spool against reel base with
C-Clamp.
b. Remove 4 nuts (b) and rotate arm to desired
position, BB, CC, DD, EE, or FF.
c. Check pawl to make sure it is not wedged.
d. Replace 4 nuts (b) and tighten securely.
To reduce the risk of injury from electric shock and
fire and explosion:
• Before installing, adding accessories or
performing any maintenance on the cord reel,
verify and/or disconnect cord reel from power
source.
• When installing a cord reel above a hazardous
location the reel must be mounted at such a
height that the lamp guard cannot reach within 18
inches of the floor.
F
IG
. 2
Overhead Installations
F
IG
. 3
a
CC
BB
b
DD
EE
FF
AA*