Graco 24F789, Инструкция по эксплуатации, Страница: 8 / 12

Instructions
8 313939E
NOTE: If you are replacing the swivel assembly, con-
tinue with Step 13, (below).
If you are just replacing
the hose, skip Step 13 and go to the Hose Replace-
ment Disassembly instructions.
Swivel Replacement Disassembly
13. Turn spool over again and loosen cap (2) to remove
swivel assembly from spool (F
IG
. 14).
NOTE: A new cap (2) is included in the swivel kit but
you do not have to remove it entirely to remove the
swivel.
If cap (2) is removed entirely and replaced with the
new one included in the kit, use a few drops of Loc-
tite
®
thread sealant to hold it securely in the hose
reel enclosure.
14. Turn spool over. Make sure shaft is still seated in
center of spool.
15. Install the new swivel assembly in the spool (F
IG
.
15). Turn spool over to access cap (2). Hand tighten
cap to hold swivel assembly in place.
16. Go to Swivel Replacement Reassembly instruc-
tions beginning on page 9.
Hose Replacement Disassembly
1. Perform Steps 1 - 12 (page 4 - 7).
2. Unwind and remove hose from spool.
3. Remove screws (n) and nuts (p) from ball stop (r)
and remove ball stop from hose end. Keep all ball
stop parts for reassembly.
Hose Replacement Reassembly
1. Insert elbow fitting (m) end of hose through opening
in spool (F
IG
. 17).
F
IG
. 14
F
IG
. 15
2
2
F
IG
. 16
F
IG
. 17
p
n
r
m