Graco 127650, Инструкция по эксплуатации

Страница: 12 / 80

12 M0303
EN
J1.1 PARTIAL RESET (NORMAL MODE)
The partial register can be reset by pressing the reset key when the
meter is in standby, meaning when the display screen shows the
word “TOTAL”.
After pressing the reset key, during reset, the display screen first of
all shows all the lit-up digits and then all the digits that are not lit up.
At the end of the process, a display page is first of all shown with the
reset partial and the reset total
and, after a few moments, the reset total is replaced by the non reset-
tableTotal.
J1.2 RESETTING THE RESET TOTAL
The reset total resetting operation can only be performed after reset-
ting the partial register. The reset total can in fact be reset by pressing
the reset key at length while the display screen shows reset total as
on the following display page:
Schematically, the steps to be taken are:
1 Wait for the display to show normal standby display page (with
total only displayed)
2 Press the reset key quickly
3 The meter starts to reset the partia
4 While the display page showing the reset total is displayed
Press the reset key again for at least 1 second
5 The display screen again shows all the segments of the display
followed by all the switched-off segments and finally shows
the display page where the reset Reset Total is shown.
J2 DISPENSING WITH FLOW RATE MODE DISPLAY
It is possible to dispense fluid , displaying at the same time::
1 the dispensed partial
2 the Flow Rate in [Partial Unit / minute] as shown on the following
display page:
Procedure for entering this mode:
1 wait for the Remote Display to go to Standby, meaning the display screen shows Total only
2 quickly press the CAL key.
3 Start dispensing
The fl w rate is updated every 0.7 seconds. Consequently, the display could be relatively unstable at
lower fl w rates. The higher the fl w rate, the more stable the displayed value.