17
1/4" X 3/4" Phillips
Pan Head Screw
1/4" X 1" Phillips
Pan Head Screw
NOTE: This illustration shows the Middle Leg
Brace assembled to the Middle Legs. Do this
AFTER you have installed you Middle Legs to
the frame (Step 14).
1/4" Plastic Knob
1/4" Nylock Nut
1/4" Flat Washer
1-1/4" Fender
Washer
Instructions continued from previous page
• The 1/4 X 3/4” phillips pan head screw goes through the
aluminum track support to the Side Leg Brace. (as illustrated left).
• Two of the 1/4 X 1” phillips pan head screw go through the
front Left Frame End to screw into the aluminum track support,
similar to what you just did on the back.
• Follow the above instructions to attach your Right Frame End
to your table, except the Left Frame End can hold up your table.
Step 13: Middle Leg Installation
Parts Needed: 1 or 2*- Middle Leg (assembled)
2 or 4*- 1/4” Plastic Knob
2 or 4*
- 1-1/4” Fender Washer
2 or 4*- 1/4” Nylock Nut
2 or 4*
- 1/4” Flat Washer
*Queen Assembly ONLY
• Lay the Little Graice on it’s side with
the front down, as illustrated.
• Put the “B” side of your Middle Leg
on the bolts, which are on the front of
your frame.
• You will have to push
the “A” Side down
enough to get it on the
bolts on the back side of
your frame.
• It is okay to tap the
leg into place with your
hand, it will be a tight fit
when you start
• The bolt to the right of
the “B” is where you will
put a flat washer followed
by a nylock nut.
