Grabo PRO-LIFTER 20, Руководство оператора

Страница: 19 / 164

19
GRABO PRO-LIFTER 20 | Operator’s manual
CHARGING THE BATTERY BEFORE FIRST USE
➐
The batteries are partially charged and must be charged to full capacity before using the
GRABO® Pro-Lifter 20 for the first time. When the batteries are fully charged, which takes
approximately two hours from the discharged state, the GRABO® Pro-Lifter 20 motor can run
for up to 1.5 hours. See CHARGING THE BATTERY.
OPERATING THE GRABO® Pro-Lifter 20
1. Slide the power ON/OFF switch
Ⓓ
into the ON position. The run status indicator
Ⓖ
lights
up red and the digital display
Ⓔ
shows the amount of available charge and the current
pressure. NOTICE: If the last bar of the battery bar indicator flashes red, the battery needs
to be charged (see CHARGING AND CHANGING THE BATTERY).
! CAUTION: Using the GRABO® Pro-Lifter 20 while the battery is low may result in injury
and damage to the materials being lifted. It is advisable to fully charge the battery before
using the GRABO® Pro-Lifter 20.
2. As an option, press the measurement unit selector
Ⓕ
to change the pressure unit
measurement from bar to psi and weight units from kg to lbs.
3. Position the GRABO® Pro-Lifter 20 firmly against the surface of the object you want to lift.
4. Press the green motor power button
Ⓒ
. The run status indicator
Ⓖ
flashes red. A seal is
created within seconds. When the negative pressure reaches the maximum level, the run
status indicator
Ⓖ
turns green and the motor stops automatically.
5. Lift and move the object.
! When lifting materials with dusty, dirty, or moist surfaces, remove the dust and dirt as
much as possible. The GRABO® Pro-Lifter 20 will automatically turn the pump on and off
to maintain the pressure necessary for safe lifting.
! For maximum safety, switch the display to weight units (kg / lbs) and compare the
displayed values with the weight being lifted, based on the “Maximum lifting force” table.
Do not try to lift any weights heavier than the value displayed.
TO END OPERATING THE GRABO® Pro-Lifter 20
1. When you are done and the object is in a secure and stable position, press the green
motor power
Ⓒ
button to stop the vacuum pump. Press the red vacuum release button
Ⓑ
to break the seal and release the object.
CHARGING AND CHANGING THE BATTERY
➐
Charge the battery when the capacity is low or the battery is empty.
1. Slide the battery latch to unlock the battery
Ⓐ
.
2. Remove the battery.
3. Connect the battery with the multi socket battery charger to a wall socket.
4. When the battery is fully charged, the battery bar indicator
Ⓠ
turns green.
5. Disconnect the multi-socket battery charger from the wall socket and battery.
6. Put the battery in the battery compartment.
7. Press and slide the battery latch to lock the battery.