www.globalplasmasolutions.com
Once the spacer is placed over the male end of the device, twist the sections together until the parts are snug, and
the carbon fiber brushes are pointing in the same direction, as shown in FIGURE 4A. Please note, once the bars are
assembled, there should be no “wobble” between the sections. Proceed to 2.
Step 1B – Assembly of snap-type GPS-iMOD
Once the mounting location has been verified, assemble the modular sections by inserting the post-end of the iMOD
into the receiver-end of the first modular section already attached to the powerhead (see FIGURE 7). Attach iMOD
sections, making sure they are properly aligned as shown in FIGURE 8. Attach the iMOD sections by using a rubber
mallet and carefully tapping with enough force to cause the modular sections to “snap” together (see FIGURE 9). Set
iMOD on hard, flat surface when assembling with mallet. Hold iMOD firmly while tapping with hammer to avoid slipping.
Do not hold iMOD between sections while assembling to avoid pinching.
CAUTION: Once iMOD sections are snapped together, they cannot be disassembled without breaking off the end piece.
Continue assembling the modular sections until you reach the needed length for the coil. After assembling the
first 8 iMOD sections, lay the assembly on floor with the powerhead firmly butted against a rigid wall. See FIGURE
10. Continue to add iMOD sections until you reach the required length of the assembly. Proceed to 2.
2. Once the last iMOD section is added, push the nylon end cap into the receiver end of the last iMOD section. It
will “snap” into place with proper pressure. Refer to FIGURE 11.
3. Verify all iMod sections are engaged and the end cap is installed prior to mounting in the air handler.
!
