Gorenje Pantry kitchen, Инструкция по эксплуатации

Страница: 15 / 16

15 Instructions for Use
Trouble-Shooting Guide
• Do not forget to clean also the defrost
water receptacle above the refrigerator
compressor (do not remove the
receptacle).
After cleaning, connect the appliance to power
supply and reload the packages.
Switch Off the Appliance When Not In Use
If you do not intend to use the appliance for
a longer period, set the thermostat knob to
the
STOP (0) position, disconnect the power
supply, take out the foods and defrost and
clean the appliance. Leave the door slightly
open.
Sink
The sink is made of stainless steel and can
be cleaned with any of the special cleaning
agents for stainless steel. Always consider
the instructions given by the manufacturer of
thecleaning agent.
The user can come across troubles appearing
during the operation of the appliance. We are
listing some of troubles, which in most cases
result from improper handling of the appliance
and can be eliminated by yourself.
The Appliance Fails to Operate After
Connecting to the Mains Supply
Check the supply in the outlet socket and make
sure the appliance is switched on (thermostat
knob in operating position).
Continuous Operation of the Refrigerating
System
• the door was frequently opened or it was
left opened for too long;
• the door is not properly closed (the door
may sag, the gasket may be polluted or
damaged);
• perhaps you have overloaded the
appliance with fresh foods;
• The reason may be inadequate ventilation
of the compressor and condenser (assure
adequate air circulation and wipe off the
condenser);
Ice Formation on the Inner Rear Wall
As long as the defrost water runs to the
channel and through the opening to the drain
pan on the compressor, automatic defrosting
of the appliance is assured. In case the ice
formation on the inner back wall is increased
(3-5 mm), ice should be manually defrosted.
Set the thermostat knob to
STOP (0) position
and leave the door open. Never use electric
devices for defrosting and do not scrape the ice
or frost layer with sharp objects.
After completed defrosting, turn the knob to
desired position and close the refrigerator door.
The cause of increased ice formation may be
one of the following:
- the door does not seal well (clean the
gasket if it is contaminated, or replace it
if it is damaged);
- the door was frequently opened or it was
left opened for too long;
- the food stored in the refrigerator was
warm;
- the food or dish is touching the inner
back wall.