Gorenje HPWW12, Инструкции по установке и запуску, Страница: 4 / 64

Water-to-water Heat Pump
4
2. Safety Warnings
The heat pump is NOT firmly fixed to the wood transport palette.
Do not tilt the pump more than 45
o
during transport.
The sidewalls of the pump are not load-bearing, and must not be loaded during installation.
Before connection, flush the piping of the central heating system.
Install a filter on the heat source inlet in order to protect the evaporator from impurities deposit.
In the water-to-water heat pump, make sure the water quality from the well meets the
requirements for water pureness.
With power supply connection, observe the correct rotation field and the proper diameters of
the cable cords used.
The first start-up must be carried out by an authorised service provider in compliance with the
Installation and Start-up Instructions.
In order to prevent oxidation in the central heating system and heat pump condenser, add an
anti-corrosive agent to the water.
Any repairs and adjustments to the pump must be made by a Gorenje authorised servicing
technician only.
Before any repair, disconnect the pump from the power supply source.
Warning labels are fixed to the rear wall of the heat pump, and
a wiring diagram can be found on the inner side of the metal
cover.