Gorenje HPWW12, Инструкции по установке и запуску, Страница: 13 / 64

Water-to-water Heat Pump
13
6. Delivery and Installation
Storage and Transport
Transport the heat pump in an upright position; when absolutely necessary, the pump may be tilted
to a maximum of 45
o
. Be careful during transport to avoid damage to the housing or to vital parts of
the unit.
The heat pump can also be moved without the use of the palette, by using the openings on the
bottom sidewalls. Push the metal rods through the opening (adequate load-bearing capacity and
max. diameter of 30 mm).
Store the heat pump in an upright position in a dry and clean place.
Placing and Installation
Place the heat pump in a well-ventilated room, avoid exposure to extreme dust and aggressive
substances. Make sure the temperature in the room is never below freezing and the air humidity is
not too high.
Place the heat pump horizontally on a firm floor with adequate load-bearing capacity. The lower
part of the frame should stand firmly on the floor in order to assure adequate sound protection.
Make sure the room has a floor drain.
Place the heat pump in a room where the noise will not disturb the environment, placing the rear
wall of the pump facing the wall. Do not place the heat pump in a room adjacent to a bedroom or
other rooms where the noise could disturb the residents.
Do not install the piping along bedroom walls or walls of other rooms where the noise might disturb
the residents. Let the installation technician mount special damping elements between the unit and
the piping in order to reduce vibration transfer from the unit into the environment. Next to the unit
dimensions, take into account additional space behind, above and to the left and right of the unit,
and especially in front of the unit.