- 24 -
NTSC Playback
Connect NTSC VCR player to Euroconnector
/ RCA Jack at the back / front of the TV.
Then, press
button to select AV-1 or
AV-2 or FAV or RGB modes.
NTSC 3.58/4.43
system can be watched at
this mode automatically.
Copy Facility
Source selection for VCR recording.
Select
TV Config.
Menu in the Installation
Menu.
Select
AV2 OUTPUT
Output source
pressing or button.
After selecting, you can copy the Audio and
Video signals of the source you had se-
lected, from AV-2 or Back AV Out, by using a
VCR.
Search for and store the test signal
of the video recorder
Unplug the aerial cable from the aerial
socket
ANT
of your video recorder.
Switch on your TV and put the video re-
corder on the test signal. (See the hand-
book for your video recorder.)
Enter the Tuning menu via the Installation
menu.
Search for the test signal of your video re-
corder in the same way as you searched
for and stored the TV signals. See Tuning,
Search and Store TV channels. Store the
test signal either under programme num-
ber 0 or between 55 and 99.
Replace the aerial cable in the aerial
socket
ANT
of your video recorder once
you have stored the test signal.
Camera and Camcorder
To connect to Front-AV input:
Connect your camera or camcorder at the
front side of your TV.
Connect your equipment to the TV via
VIDEO,
AUDIO R
and
AUDIO L
inputs . You
should connect the jacks to the input in the
same colour.
To connect to Back-AV output:
Connect your camera or camcorder at the
back side of your TV.
Connect your equipment to the TV via
VIDEO,
AUDIO R
and
AUDIO L
inputs . You
should connect the jacks to the input in the
same colour.
Connect the decoder to the video
recorder
Some video recorders have a special Euro-
connector / RCA Jack for decoder.
Connect a eurocable (RCA Jack Cable) to
the Euroconnector / RCA Jack of your de-
coder and to the special Euroconnector /
RCA Jack of your video recorder. See also
the handbook of your video recorder.
To connect your video recorder to the TV,
see TV and Video Recorder section.
If you want to connect more equipment to
your TV, consult your dealer.
Connecting External Speakers
Your TV set has two outputs (one for left and
one for right speaker) to provide connection
for external speakers. You can connect loud-
speakers of minimum 8 ohms (12 watts) to
these inputs.
When you connect external loudspeakers,
the internal loudspeakers of your TV will be
switched off automatically.
Connecting Headphones
Use the stereo headphone socket (HP) of
your TV on the left side, to connect head-
phones.
Tips
Care of the Screen:
Clean the screen with a slightly damp, soft
cloth. Do not use abrasive solvents as they
may damage the TV screen coating layer.
Poor Picture:
Have you selected the correct TV system? Is
your TV set or house aerial located too close
to the loudspeakers, non-earthed audio
equipment or neon lights, etc. ?
ENG-2883-M-AV-3D PANORAMA-GOODMANS GTV69RF-2 SCART-FAV-BAVOUT.p65
05.08.2002, 10:31
24
