Dog Silencer™
Instruction Manual
Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
We’re Here to Help
Toll Free:
1-800-657-8214
Outside US:
1-541-245-4488
Caution
Changes or Modications not expressly approved by the party responsible could void the user’s authority to operate this device.
Warning
Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. This product need power supply by adapter that can meet LPS. The
maximum operating temperature is 45°C.
IS THIS DEVICE LEGAL TO USE ON A NEIGHBOR’S DOG?
Because the Dog Silencer relies on ultrasonic sound as a training method, it is outside the human hearing range and is not typically covered
under noise ordinances. Additionally, due to the way noise is measured (A-weighting), the Dog Silencer can normally be used in environments
where OSHA regulates ultrasonic sound levels. That said, we don’t recommend using the Audio setting for neighbor’s dogs.
THE DEVICE ACTIVATES EVEN WHEN THE DOG DOESN’T BARK!
You might have the bark sensor set too high, which means it may be activating to noises unrelated to barking. Try turning the bark sensor down
slightly so that noise or loud sounds do not trigger it.
ARE THERE ANY DOGS THIS WON’T WORK ON?
We don’t recommend the Dog Silencer for dogs younger than 1 year as their ears are still developing and may be very sensitive. Older dogs may
have high-frequency hearing loss that could prevent the ultrasonic sound from being effective. Check with your veterinarian if you have a puppy
or suspect that your dog has hearing loss.
SHOULD I USE THE ‘AUDIO’ SETTING?
You have two options - the ‘Ultra’ setting emits ultrasonic sound while ‘Audio’ emits both ultrasonic and audible sounds at the same time. We’ve
found customers have the most success using the ‘Ultra’ setting, but if you have an especially stubborn dog, try ‘Audio’.
INSTINCTUAL VS. HABITUAL BARKING
Heads up! Instinctual, territorial and protective barking may be more difficult to train than barking out of boredom or habit.
Returns & Exchanges
Don’t worry, we’ve got you covered! Your Dog Silencer is backed by our 45 Day Money Back Guarantee and 1 Year Protection Plan. In the unlikely
event you need to use either of these, just contact us and we’ll make it right. If you bought your Dog Silencer from a retail location, please con-
tact the store directly for return details. If instead your purchase was made through Good Life, please visit www.goodlifecompany.com/returns or
contact us using the information below for full details.
Need more? You can extend the Protection Plan on your Dog Silencer to 2 or 3 years, or even add accidental coverage by purchasing one of our
easy Protection Plans. Visit us at www.ultimatebarkcontrol.com or contact us using the information below to purchase.
Troubleshooting
THE DOG IS BARKING THE SAME OR MORE THAN BEFORE!
No problem. Dogs may bark a little more at the start of the training process. This is only temporary while the dog is being deterred by the ultra-
sonic sound and is trying to resist training.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the device.
Website:
www.ultimatebarkcontrol.com
Email:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’ap-
pareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
©2014 Good Life, Inc. DESIGNED IN OREGON MADE IN CHINA
