Mounting Preparations
2a
2
3/16 (.19) in./6,4 mm
masonry bit
Drill a 3/16 in. hole and place the masonry anchors in the pilot
holes. Hammer them into place until flush with the surface.
Drive long screws into masonry anchor until snug.
There are 2 methods to mount the fixture, wood
surfaces and masonry (see below).
Once the light is mounted, the light head can rotate a full 360°
to better direct light where needed. Once the direction has
been determined, tighten the knob to lock the light head into
place.
The adjustable knob on the arm operates the angle of the lamp
head. Adjust to wall, eave, or deck mount and then tighten.
Proceed to the installation steps below.
1
2
Adjusting the light position
There is an adjustable knob located directly below the light head. The light head can easily be
adjusted for WALL MOUNT, EAVE MOUNT, or DECK MOUNT.
ADJUSTABLE KNOB
2b
1/16 (.0625) in.
1,6 mm
If mounting onto wood surface, drill 1/16 in. hole
and use the wood screws provided to secure the
mounting plate.
5
