GÖLZ Bridge Saw, Оригинальное руководство по эксплуатации

Страница: 43 / 86

10 Faults
43 / 86
Fehlermeldung / Störung Mögliche Ursache Beseitigung Personal
High segment wear Segment binding too soft Use blade with harder
segments, or reduce feed
pressure
Operating personnel
Segments too narrow in
relation to motor power
and feed pressure Reduce feed pressure, or
use blade with wider
segments
Number of segments too
low Use blade with more
segments, or reduce feed
pressure
Blade beats Use new blade, have old
one straightened, check
cutting shaft, use new one
if necessary
Blade runs Check table guide, replace
if necessary
Abrasive aggregates Use blade with harder
segments
Feed pressure too high Reduce feed pressure
Saw blade has lateral and
vertical runout Saw blade bent or
damaged Have the saw blade
straightened, solder
segments onto new blade
or new saw blade Manufacturer
Flanges dirty or
damaged Clean or replace flanges Operating personnel
The motor shaft is bent Replace the electric motor Qualified electrical
personnel
No power when cutting,
saw blade blunt No saw blade matched
to the material Use the correct saw blade Operating personnel
No saw blade matched
to the machine output
Saw blade too hard
Diamonds on segment
are blunt sharpen Technical staff
Cutting process not
optimal Segments blunt sharpen Technical staff
Saw blade too heavily
loaded Use a suitable saw blade Operating personnel
Saw blade tension bad Send in saw blade Manufacturer
The mounting hole of the
saw blade has run out Saw blade has rotated
on the motor shaft Check the mounting flange,
if necessary
exchange Manufacturer
Unscrew the location hole
and fit the exact ring Technical staff