9
DOOR PANEL INSTALLATION
Configuring the contact type for Relay 1 and Relay 2 (lock release):
To change the contact type for lock release activation of Relay 1 and Relay 2 of the door
panel, follow these steps:
- Set dip 6 of the sound module's con
#
guration dip switch to ON (see page 6), a
con
#
rmation tone will be heard.
- Use the sound module's P2 push button to select the desired contact type (N.O
factory default or N.C).
- Each press will change the contact type. A long con
#
rmation tone will be heard if the
selected contact is N.O or two short tones if the selected contact is N.C. Stop pressing
P2 when the desired tone is heard.
- Once
#
nished set dip 6 on the con
#
guration dip switch to OFF.
A con
#
rmation tone will be heard.
P2
Inserting the push button identification labels:
Open the label holder.
Insert the label
and close.
Important
:
The selected contact type will apply to both Relay 1 and Relay 2.
Description
:
Normally open: N.O.
Normally closed: N.C.
Closing the door panel:
Once the door panel has been correctly wired, configured
and adjusted, fix it to the embedding box using the
tamper-proof screws and ¼
”
tamper-proof screwdriver bit
supplied.
Important:
-
.
Before closing the door panel, make a test call to any apartment to ensure that everything works correctly
-
.
Keep the tamper-proof screwdriver bit in a safe place in case the door panel needs to be reopened
To insert the push button identi
#
cation labels, remove the sound module from the door panel to access the label
holder and use a
$
at screwdriver to gently lever open the fastening clips, as shown in drawing A . Once the
identi
#
cation labels have been inserted, reattach the sound module to the door panel. Line up the tabs on the sound
module with their respective fastening clips and then press gently until correctly positioned.
*
( )
A
Fastening clips (x4).
STAINLESS STEEL NEXA MODULAR GB2 VIDEO SYSTEM KIT – VILLAS
