10
9. Top tweeter mounting.
For each speaker you will need:
-1 top tweeter
(Tweeters)
- 2 plastic translucid feet
(Tweeters)
- 1 fake piece of wire
(Tweeters)
- 1 arm among the longest (Frame)
- 1 frame rectangular arm holder (Tweeters)
- 1 cylindrical head screw (Tweeters)
- 2 flat head screws (Tweeters)
- 1 threaded bar
(Tweeters)
- 1 molette
(Molettes)
Mount the two plastic translucid feet on the midrange section. Insert a fake piece
of wire in the foot where the tweeter cable will not pass.
Warning :
During the following operation, be careful again to keep the arm from
touching the midrange section.
To mount the frame armmount, first, in the corresponding hole of the oblique legs,
the frame rectangular arm holder, using the cylindrical head screw. (The
corresponding hole is the highest one accessible of the two inside holes which are
located on the right oblique leg for the right speaker and the left oblique leg for the
left speaker).
The rectangular part must have the two holes at the back (when the speaker is
seen from the front).
Then attach the (marked right or left depending on the speaker) arm on it with 2
flat head screws without tightening.
Place the tweeter on top of the midrange section, passing its cable through the
plastic foot and inside the midrange crossover section.
Insert, screwing, the threaded bar in the tweeter cylindrical lateral part, through the
arm.
When the top tweeter is well installed, and with one person still holding the arm to
avoid that the tweeter lose its balance, screw one molette and secure it, as well as
the two flat head screws holding the arm.
