The unit will start to dehumidify on High fan speed
and the Humidity setting is set to continuous.
The operation light will flash until the compressor
starts to run, the light will stop flashing and
remain on when the compressor has started.
The compressor will switch off automatically when
the water container is full. THE FAN WILL
CONTINUE TO RUN.
As long as the water container is not full, the
appliance will continue to operate until it is
switched off manually.
If the appliance is switched off manually and then
switched back on, the compressor will start to
operate after three minutes.
To turn the appliance off, press the POWER
button.
Use the SPEED button to switch between High
and Low fan speeds.
WHEN THE WATER CONTAINER IS FULL
A beep signal will sound 15 times.
The TANK
FULL indicator light will illuminate on the control
panel.
The compressor will stop automatically, and the
unit will stop dehumidifying.
Empty the water container and replace it in the
correct position.
The appliance will continue
dehumidifying when the compressor automatically
restarts after approximately three minutes.
HUMIDITY SETTING
Press the HUMIDITY SETTING button to select
the desired ambient relative humidity level; you
can set at CO (continuous), 50%, 60%, 70%,
80%, AU (comfort mode).
WARNING: Keep all objects at least 1 metre
from the front, sides and rear of the appliance.
WARNING: In order to avoid overheating or
risk of fire, do not cover the appliance.
WARNING:
Never
leave
this
appliance
unattended when in use.
WARNING: Do not use this appliance with a
programmer, remote-control system, separate
timer or any other device that switches the
appliance on automatically.
Note: When the appliance is turned on for the
first time, it may release a slight odour. This
odour is a normal occurrence caused by the
initial starting of the unit and should not occur
again.
Leave the appliance to stand for one hour after
transport or after the unit has been on its side
before connecting it to the mains supply to let the
refrigerant settle.
Ensure all external windows and doors are closed
before turning on the unit.
Ensure that the water container is positioned
correctly.
OPERATION
Plug into power supply and switch on at the
mains.
To turn the appliance on, press the
POWER button.
Operating your Appliance
Always choose a safe location for your appliance, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the unit
before use. This appliance requires no installation, it should be used solely
as a portable appliance.
CONTROL PANEL
