Karmel King
Model No. 2620, 2621, 2630, 2631
Page 12
gmpopcorn.com
Daily Unit Cleaning Procedure
1.
Turn machine OFF, unplug the unit and allow it to cool before attempting to clean.
2.
Clean all pans/accessories after each use.
3.
Release draw latch and remove mixing drum, then remove paddles (pull plunger knob
and lift paddle off).
Take drum and paddles to sink and clean with soap and water, then rinse and dry.
4.
With unit OFF and unplugged, use a clean SLIGHTLY damp cloth (wring ANY EXCESS
water from cloth before use) and wipe the kettle lead cord clean.
DO NOT get moisture
into the kettle lead-in cord, severe damage will result.
5.
Wipe unit clean using a cloth SLIGHTLY dampened with soap and water, then wipe
again to remove any remaining cleaner.
Weekly Cleaning of the Hub Seal Assembly
Important:
Keep the hub seal and o-rings clean for proper machine performance.
1.
Turn machine OFF, unplug the unit and allow it to cool.
2.
Pull knurled knob of plunger and lift mix paddles off shaft.
3.
Remove any burrs on the shaft using a fine grit emery paper to lightly sand the
surface—burrs can damage the o-ring/oil seal during removal/installation.
4.
Remove the hub seal assembly and soak it in hot water to clean.
5.
Clean out any sanding partials from kettle and shaft.
6.
Clean the area around the center hub. Remove any product residue. (See Kettle Shaft
Maintenance section for note on lubricating the kettle bushings.)
7.
Lightly lubricate the center hub of the kettle with a small amount of Petro Gel to allow
for easy re-installation of the hub seal assembly.
8.
Slide the clean hub seal assembly down the agitator shaft. Apply pressure to ease the
assembly over the center hub of the kettle until it seats properly.
9.
Re-install the mix paddles—make sure the plunger of each paddle securely sets into
its hole in the shaft.
Mixing Paddle
Jaw Coupling
(2 Socket HD Cap Screws
hold Kettle Shaft)
Knurled Knob
of Plunger
Hub Seal Assembly
(Includes Oil Seal, O-Ring,
and Hub Body)
Oil Seal
Hub Body
O-Ring
Agitator Shaft
