Fudge Cooker/Mixer
Model No. 2183-00-000
Page 13
gmpopcorn.com
Care and Cleaning
DANGER
Machine must be properly grounded to prevent electrical shock to personnel.
DO NOT immerse in water.
Always unplug the equipment before cleaning or servicing.
025_020314
WARNING
To avoid serious burns, DO NOT touch the kettle while it is hot!
028_020314
Good sanitation practice demands that all food preparation equipment be cleaned regularly (only
use non-toxic, food grade cleaners). A clean looking, well-kept machine is one of the best ways of
advertising your product.
Fudge Unit Cleaning Instructions
Note:
It is extremely important to follow all of the cleaning procedures, otherwise parts
damage and equipment failure will result. The warranty does not cover parts that
are damaged due to improper cleaning.
Proper Kettle Cleaning Procedure
Follow the procedure below to steam the kettle every 3-4 batches during regular operation and
before the machine is turned off for the day. The kettle must also be steamed out after making
single batches, if the machine is turned off between batches, or if changing flavors.
Total Cleaning Time:
Approximately 20 minutes
1.
After all product has been removed, with machine OFF, use included spatula to scrape
as much excess dried fudge as possible from inside the kettle and around the paddle.
2.
Carefully pour in enough water to fill the kettle to right below the drum seal; this
should be approximately 1.75 gallons.
3.
Turn Heat/Motor Switch ON and ensure toggle switch is in the CLEAN position; the
preset set point temperature is 230°F.
4.
Put the lid on the kettle and let the machine run for approximately 20 minutes; the kettle
will steam and wash the residue into the water, then turn Heat/Motor Switch OFF.
CAUTION: Beware of rising steam; keep face and hands clear of rising steam
.
5.
Allow unit to cool, then remove lid and carefully pour dirty water into a bucket,
discard appropriately, then wipe inside of kettle with a clean cloth or paper towel to
finish cleaning.
For extremely dirty kettles, we recommend running the cycle twice.
