Goff 2460, Руководство по эксплуатации и обслуживанию

Страница: 69 / 105

l
question with a qualified electrician or your local electrical repair center can help you
determine whether repair or replacement would be most economical for you.
GEAR REDUCERS
All Goff equipment uses high quality wonn gear speed reducers. The lubricant
should be changed after the first 100 hours of operation. Drain out initial oil and flush
out the gear case with an approved non-flammable, non-toxic solvent and refill.
Thereafter, oil should be changed at least every 2500 operating hours or once a year
whichever comes first. If unit is operating in extremely dirty or high/low temperature
environments, change oil more often. A high grade, mineral base worm gear oil is
recommended for lubrication. An approved list for worm gear speed reducers is shown
below:
Texaco
Texaco
American
Gulf
H umble
Shell
M obil
Chevron
Std. of Indiana
Std. of Ohio
Meropa #3
650 Cylinder Oil
196L Cylinder Oil
Senate 186
Cy lesso TK-190
Valvata J82
Super Cylinder 600W
Gear Comp. 240
Calumet SH Cylinder Oil
Sohicyl 650
Keep shafts and vent plug clean to prevent foreign particles from entering the
seals or the gear case. Inspect periodically for oil leaks. Check couplings, set screws and
reducer mounting bolts for tightness (loose fasteners can cause alignment problems and
excessive wear). Check the end play in shafts. Noticeable movement might indicate
service or part replacement is necessary. A high grade, 1 0-W-40 motor oil is
recommended fo r the elevator drive torque arm reducer.
SCREEN SYSTEMS
The abrasive undergoes a screening process to remove any objects or tramp metal
that might have been mixed into it during the blasting operation. The screen system
permits the abrasive to pass but removes trash and tramp material from the system. If
trash and tramp material were to pass through the blast wheel severe damage could occur
to the blast wheels. The primary screen, located immediately under the blast chamber,
6-3