Goff 2460, Руководство по эксплуатации и обслуживанию

Страница: 81 / 105

10. Gear Reducers
- Inspect Monthly
Replace gear oil every 2500 hours or annually.
Check the manufactures nameplate attached to each reducer for the correct lubricant to
use. Check for oil leaks. Check for end play in shafts and all bolts retaining hardware.
Noticeable movement might indicate service or part replacement is necessary.
1 1 . Bearing
- Inspect Every Six Months
Bearings are lubed for life. Excess lubricant can cause abrasive contamination in the
bearing and result in premature bearing failure.
12. Electric Motors
- Inspect Monthly
Add a small amount of oil occasionally. Excess lubricant can cause abrasive
contamination in the bearing and result in premature bearing failure.
13. Hydraulics
- Weekly
Inspect filter and replace when necessary. Check and replace fluid annually or as
conditions warrant. Keep area as clean as possible.
14. Pneumatic Components
- Monthly
Air cylinders and lines should be checked for proper operation and wear and leaks.
15. Cabinet and Barrel Head Liner
- Inspect Daily
Replace when worn to half original thickness.
16. Mill Belt
- Inspect Daily
Replace when worn and/ or frayed or when stretched to point where belt will not track.
17.
Nozzles
- Inspect Daily
Since abrasive passes through the nozzle's orifice, the orifice will over time become
larger. If you notice an increase in cleaning time replace the nozzle.
18. Belt Conveyor
The abrasive return belt serves to transport the abrasive and sand mix to the abrasive
screen conveyor.
7-3