Goff 2460, Руководство по эксплуатации и обслуживанию

Страница: 63 / 105

l
OPERATING PROCEDURES
NOTE: Operator should wear eye protection during operation of this equipment.
1.
Press "Abrasive Reclaim Start" button to start the abrasive recycling system and optional
dust collector.
2. Press "Spinner Start" button to start the spinner drive.
3. Select "Chamber On".
4. Select "Abrasive On".
5. Load chamber with parts.
6.
One or both of the blast wheels may be used for blasting depending on the parts and cleaning
that is desired. To stop a blast wheel, press the "Blast Wheel Stop" button and any wheels
that were left on from previous cycles will be stopped. Press the blast wheel start buttons for
those wheels to be used.
7. Set blast cycle timer to desired blast time.
8. Press "Chamber Index" button to start the blast cycle.
9. Parts may be unloaded and loaded to the next chamber when it comes to the loading station.
The chamber will rotate short distances as the blast cycle advances through the blast
positions.
10. After the blast cycle timer times out at the last blasting position the chamber will advance a
short distance then the abrasive and chamber will stop.
11. Repeat steps 7 through 10 for remaining blast cycles. Allow abrasive reclaim to run between
cycles to refill the abrasive hopper for next blast cycle.
12. Before shutting down the machine allow the abrasive reclaim and optional dust collector to
run for 1-2 minutes to refill the abrasive storage hopper.
13. To shut down the machine press "Emergency Stop" button.
5-2
sec5/10-2 460/3672SP2BW