12
Power Switch of AF Assist Beam
Slide the AF-assist beam switch to ON, and the AF lighting is allowed to output. When the
camera cannot focus, the AF assist beam will turn on, when the camera can focus, the AF
assist beam will turn off.
Channel Setting
•
Long press the <Zm/CH> button and the channel value will be chosen.
•
Turn the select dial to choose the appropriate channel. Press the <SET> button
again to confirm the setting.
•
This flash trigger contains 32 channels which can be changed from 1 to 32. Set
the transmitter and the receiver to the same channel before usage.
Wireless ID Settings
Change the wireless channels and wireless ID to avoid interference for it can only be
triggered after the wireless IDs and channels of the master unit and the slave are set to
the same.
Press the <MENU> button to enter C.Fn ID. Press the <SET> button to choose OFF
channel explosion shutdown, and choose any figure from 01 to 99.
Note: As the current Godox flashes do not have wireless ID setting functions, please set
ID to OFF.
Mode Setting
•
Short press the <MODE> button, and the mode of the current group will change.
•
Set the groups to five groups (A-E)
o
When displaying multiple groups, press the <MODE> button to switch the
multi-group mode to MULTI mode. Press the group selection button can
set the MULTI mode to ON or OFF.
o
When displaying multiple groups, press the group selection button or
<MODE> button in one-
group mode, and all the current group’s mode will
be changed by the order to TTL/M/--
•
When setting the group to 16 groups (0-F), there is only manual mode M.
•
Long press the <MODE> button for 2 seconds until “LOCKED” is displayed on the
button of the LCD panel, which means the screen is locked and no parameters
can be set. Long press the <MODE> button again to unlock.
