10
Chapter 2. Printer Installation
This printer model has the following print modes:
Thermal Transfer (TT) : When printing, ribbon must be installed to transfer the print contents onto the media
Direct Thermal (DT) :
When printing, no ribbon is necessary; it only requires direct thermal media.
Please check the specific print mode, then go into the Setting Mode after power on the printer.
2-1. Ribbon Installation
1. Place the printer onto a smooth surface, and
open the top cover.
2. Pull the Print Head Lever out and flip it
upward to the right.
3. Take the used ribbon out of the ribbon
supply shaft.
4. Place the new ribbon roll onto the ribbon
supply shaft.
5. Place the empty ribbon roll onto the ribbon
rewind shaft.
6. Feed the ribbon from the Ribbon Supply
Shaft Rod under the Print Head.
Note: DO NOT feed the ribbon under the
moveable sensor.
