10
REV.01
INSTALLATION INSTRUCTIONS
© 2016 Go Rhino Products. All rights reserved
Vehicles without factory tow hooks:
Step-2.1 From the opening at the end of the driver side frame, position (1) M12 t-bolt inside the frame
with the bolt extending out through the obround shape hole on the side of the frame. Install (1) vinyl
gasket on the bolt to keep the t-bolt from falling back into the frame. Repeat to install (1) M12 t-bolt in
the round hole on the side of the frame Note: To ease installation use the supplied pull wire to fish the
t-bolts from the opening and out through holes in the frame.
Step-3.1From the front of the bumper position the driver side mounting bracket through the opening
in the bumper lower cover and up to the side of the frame, align the holes in the mounting bracket with
the M12 t-bolts, then secure the mounting bracket to the side of the frame using the M12 t-bolts, (2) ½”
flat washers, (2) ½” lock washers and (2) M12 hex nuts. Snug but do not tighten the nuts, (Fig 6).
Repeat the step 2.1 and 3.1 for the passenger side mounting bracket.
Fig 6
Driver side shown
N-L
K-M
P
12
