9.
Leveling the Fan
1.
After your fan is installed, check the level again by placing your level vertically on the
vertical post of the fan frame. Adjust as required.
2.
Once leveled,
tighten hardware to a minimum 40 ft-lbs (54.2 N.m) to secure
the Down Tube into the
Upper
Yoke. Verify fan level once hardware is tightened.
ATTENTION! Motor Gearbox Vent
1.
Remove rubber stopper
from the gearbox
2.
Discard after removal.
For proper electrical connection, please consult the Wire Connections (Motor) page later in this document.
Fig.19
Failure to remove the vent stopper will cause gearbox failure!!
|
2
0
Z-TECH™
FAN
Installation and Technical Operations
®
GO FAN YOURSELF
ABB Dodge vent
plug shown in
place. This must
be removed
before motor
operation.
Vent shown with
plug
removed.
ABB Dodge Motor Vent Plug
