1.
Tools Required to Install Product
•
Level
•
High torque 1/2" impact gun with impact socket set
•
Torque wrench capable of 30 ft-lbs +/- 2 ft-lbs
•
Standard socket set
•
Standard wrench set
•
Scissor or Boom Lift
2.
Required Steps Before Installation
•
Check to see if you have all the tools required for the installation.
•
Verify that all fan components were received.
•
Check drawings and layouts provided to locate where the Z-Tech
TM
Fan is to be installed.
•
Each person installing the Z-Tech
TM
Fan must use a safety harness at all times.
•
Other safety requirements may be required for installation.
•
All workspace safety requirements and lock out/tag out procedures provided by the customer
for the assembly and installation of the Z-Tech
TM
Fan must be met and followed.
Follow the Factory Mutual Insurance Company (FM Global) standards, Heating equipment manufacturer’s guideline
and safety standards such as those published by the National Fire Protection Association (NFPA), and the American
Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and local code authorities.
WARNING: A structural engineer will need to verify that the structure is suitable prior to the installation of the fan. The fan
should not be installed unless the structure on which the fan will be mounted is securely constructed, without damages, and can
support the load of the fan. It is the sole responsibility of the customer/end user to have the stability of the mounting
structure verified. Go Fan Yourself hereby denies any liability resulting from the lack of verification or from the use of any
®
materials or hardware than those supplied by Go Fan Yourself
®
or otherwise indicated within these installation instructions.
Start your installation
3. Different Mounting Applications
Note:
The following mounting applications
are representations only and are subject to
change without notice. Contact your sales
representative or the Go Fan Yourself
®
office for complete mounting instructions
.
“I” Beam Mounting
Fig.2
Insert optional shims (found in bottom tray
of your fan packaging) to keep Beam Clamp
Plates near level if I-Beam is thicker than
the bend in the Beam Clamp Plate. Shims
insert on top of the Upper Yoke Assembly
and are secured with the mounting
hardware. See picture above and following
pages for additional details.
|
10
Z-TECH™
FAN
Installation and Technical Operations
®
GO FAN YOURSELF
