GNATUS Optilight Max, Руководство пользователя

Страница: 20 / 28

20
PRECAUTION, RESTRICTION AND WARNING
Precautions and warnings “during the use” of the equipment
Precautions and warnings “after” the use of equipment
- Turn the equipment off while in not in use for a long time.
- Carry out the cleaning and disinfection after the use of the equipment, including in the first use.
- Do not change any part of the equipment. Do not disconnect the cable or other connections
unnecessarily.
- The batteries should not be stored inside the equipment if it becomes unused for some time. When
it’ is not using the equipment, we advise you to remove the batteries, because they are corrosive
and can, throughout time, release the acid and cause damage to it.
- When observing the presence of irremovable stains, cracks or fissures on the light conductor and
ocular protection, provides the replacement of the damaged components.
Precautions and warnings “during installation” of the equipment
- Check the voltage of the equipment when performing the electrical installation.
- Place the equipment at a place that will not get wet.
- Install the equipment at a place where it will be not damaged by pressure, temperature, direct
solar light, powder and salt.
- The equipment shall not be submitted to bending, excessive vibrations or shocks (including while
transporting and handling).
- This equipment was not designed for the use at an environment where fumes, inflammable anesthetic
mixtures with the air or oxygen and nitrous oxide can be detected.
- Before the first use and/or after long work interruptions such as vacations, clean and disinfect the
equipment.
- This equipment is not sensible to electrical interference; electrostatics and pressure, since cleaning
items, maintenance, transport and operation of this manual are observed. However, an electromagnetic
environment can interfere in its normal operation.
- The equipment must only be operated by technicians duly qualified and trained (Dental Surgeons
and Capacitated Professionals).
- In case of a casual maintenance, only use the services of a Alliage’ Authorized Technical Assistance.
- Do not submit the plastic parts to contact with chemical substances used in the dental treatments
routine Such as: acids, mercury, acrylic liquids, amalgams, etc.
- Avoid that the light conductor’s terminal touch the resin to be polymerized.
- When using the photopolymerizers, check if the outlet of the conductor has no residues that can
occlude the light beam.
- Use appropriated techniques for minimizing the effects of the contraction of the photo polymerized
material and also of the temperature on the applied region; these techniques consist of a proportional
detachment from the expected effect, which means that detaching the tip from the activated region,
the power and the temperature tends to diminish.
- A minimum distance of 10mm between the Light conductor and the tooth is recommended.
Manufacturer shall not be responsible for:
- Use of the equipment differing from that for which it is intended.
- Damages caused to the equipment, the professional and/or the patient by the incorrect installation
and erroneous procedures of maintenance, differing from those described in these Instructions for
use which come with the equipment or by the incorrect operation of it.