GNATUS Optilight Max, Руководство пользователя

Страница: 17 / 28

17
OPERATION OF EQUIPMENT
- Press the button to turn on the equipment (fig.1).
- Select the application mode pressing the selection button (fig.2), which variations are:
- Continuous: Maximum mode and continuous for light intensity (same luminosity from the beginning
to the end of the polymerization).
- Ramp: Gradual mode, light intensity increases gradually.
- Pulse: Pulse modes are cycles that oscillate at a fixed frequency.
• The chosen application mode shall be seen in the LEDs’ sequence.
• For setting time, press the button and chose a time between a time from 5 to 20 seconds, which
will be seen on the display (fig.3).
-After selecting the application mode and the choice of time, remove the light conductor protection
cover and take the handpiece to the patient’s mouth and position the light conductor at a safe
distance (fig.4).
- For starting the polymerization
cycle, press the trigger. Just
trigger again to interrupt (fig.5).
1 2 3
Press
Press
Press
4 5
10mm
beep
beep
beep
ATTENTION
Low battery:
- When the display shows the symbology and sound
the beep indicating low battery, please recharge it.
- The LED charge’s indicator (A) gets red when the battery is
charging and green when the charging is complete.
- Always keep the handpiece over the base, getting energized,
when not using it;
- The approximate time for the recharge is 4 hours. After the
recharge, the LED’s charge indicator (A) will change for green,
indicating the complete recharge;
- The battery does not have a memory effect and can be recharged,
even if it’s not completely discharged.
A
Pr
ess