Page 9
General Machine Products (KT), LLC
Jetstream machine
Duct route
Cable drum
5.0 OPERATING PROCEDURE
IT IS IMPERATIVE THAT ALL PERSONS USING, OPERATING OR MAINTAINING THIS
CABLE BLOWING MACHINE:
•
HAVE RECEIVED COMPREHENSIVE TRAINING IN THE USE OF THIS MACHINE.
•
ARE COMPETENT TO USE IT,
•
AUTHORIZED TO USE IT AND
•
HAVE READ AND UNDERSTOOD THIS MANUAL
GENERAL MACHINE PRODUCTS CANNOT BE HELD RESPONSIBLE FOR MISUSE OF THIS
EQUIPMENT.
Set up for installing cable with the machine mounted above ground:
Position the machine in line with the route of the duct.
Position the cable drum behind the machine and in line with the machine. See sketch below (this shows a
plan view of the recommended set up).
Ensure the machine is secure (either on its own stand or a separate suitable stand).
Ensure the machine is fitted with the appropriate guides and collets to suit the cable being installed and
ducts into which the cable is to be installed. (See Appendix 1 for details of interchangeable parts and
sections 7, 8 & 9 for procedures on how to fit these parts).
To set the machine up to install cable it will be necessary to:
1.
Select and set the appropriate pressure switch setting for the cable being installed.
2.
Fit the duct into which the cable is to be installed into the air box and duct clamp.
3.
Fit the cable through the machine.
4.
Connect the air supply to the machine
1
.
5.
Connect the hydraulic power input to the machine.
1
use the supplied 4
claw to round adapter
if needed
