Glutz SD-L F 9365 Series, Монтаж и эксплуатация

Страница: 15 / 112

SD‑L F (9365x)
0548-988-11---20_2022.01.indd
A
B C


D
Y
X
0548-988/12
Page 15 of 87
Mounting and operating instructions
4 MOUNTING
4.1 Preparation
Attention:
St inverse application
It is imperative for the customer to install a door leaf stop piece!
This door leaf stop piece prevents the door leaf/drive mechanism from being damaged
in the manual operating mode, in case of misuse or vandalism.
As an option, an open position stop piece can be integrated into the drive mechanism
itself, but this stop piece does not offer this protective function.
Attention:
Check the free running movement of the door leaf. Should it fail to move smoothly and
silently, or if it is out of balance (i. e. it opens or closes by itself), these problems must
be eliminated first!
Motor connector plug
Attention:
In order to ensure the cushioning function, the correct position (X or Y) of the mo -
tor connector plug (D) must be checked. This can be determined on the basis of the
following chart. In addition, the correct position of the motor connector plug (for each
available rod and assembly version) is shown in chapter 4.2.
Position Motor connector plug Position Drive mechanism
Application
Standard Invers
Lintel mounting pushing function opposite side of hinge Y X
Leaf mountin pushing function side of hinge Y X
Lintel mounting pulling function opposite side of hinge X Y
Leaf mounting pulling function side of hinge X Y
1. Loosen the two screws (A).
2. Pull the control (B) out from under the gearbox housing (C).
3. Re-connect the motor connector plug (D).
4. Remount the control unit (B).