Glunz & Jensen Plate Processor 150, Руководство по установке

Страница: 26 / 40

"
At least two persons are required for this operation. See illustration oppostie.
•
Place the machine in its final position.
•
Open the locks (1) .
•
Mount the bearings on the rollers ensuring that
–
the bearings with the small springs (2) are installed on the lower gum section
roller (3) and on the lower exit roller (4) . Normally the brushes are already
installed, but if not, make sure that all rollers (5) below the brushes are also fitted
with the bearings/springs (2) .
–
the bigger springs (6) and washers (7) must be installed between the rollers and
bearings in the end opposite the drive gears on the gum section rollers (3) and (8) .
•
Lower the rollers into the grooves and then close the locks (1) .
Installation Manual - Plate Processor 150 1049
2-18
Installation
Preparation for processing