GLP Fusion Stick FS20, Быстрый старт и руководство по безопасности

Страница: 19 / 32

German Light Products®
Fusion Stick FS20 Quick Start and Safety Manual Rev. A 19
In temporary installations, secure each fixture with a safety cable as described in
‘Securing fixtures with a safety cable’ on page 14 if there is any risk that the fixture
will cause injury or damage if it falls.
Side-to-side attachment
See Figure 10. Channels A at both ends of
FS20 fixtures accept FS20 locking pins B . This
feature lets you align fixtures to each other
quickly and accurately to form an
unbroken line of pixels.
Warning! Do not use the locking
channels and pins to support the
weight of fixtures unless the
fixtures are hanging vertically one above
the other. If fixtures are not hanging
vertically, each individual fixture must be
supported by fastening it securely to a
surface or structure as directed in this
chapter, and the locking pins may be used
for alignment purposes only.
Vertical suspension from a rigging structure
You can install the FS20 hanging vertically downwards from a rigging structure if you
use the FS20 Vertical Suspension Set optional accessory.
To install the FS20 Vertical Suspension Set on
a fixture:
See Figure 11 . Place the End Plate B on
the end of the fixture so that the locking
pin channels in the end plate and the
fixture mesh with each other.
Push the two locking pins A into the
channels in the End Plate and the fixture
so that the End Plate and fixture are
locked together. Press the button on
each pin so that you can push the pin
fully into its channel.
When the pin is fully engaged, release
the button and check that the pin is now
locked in place.
Obtain a truss rigging clamp and omega
bracket with quarter-turn fasteners that
are approved for the weight that they
will support. Check that they are in perfect condition.
A
B
Figure 10. End channels and locking
pins
Figure 11. Vertical Suspension
Adapter Set
A
B