GLP Fusion Stick FS20, Быстрый старт и руководство по безопасности

Страница: 16 / 32

www.glp.de
16 Fusion Stick FS20
Quick Start and Safety Manual Rev. A
Using FS20 Locking Pins
The FS20 system includes Locking Pins that can be pushed into channels in the ends of
fixtures and in installation hardware and then locked into place.
To install a Locking Pin:
See Figure 5. Push button A and keep it pressed in while you insert the pin into the
channels.
When the pin is fully inserted, release button A . This will lock the retaining ball B in
the ‘out’ position and prevent the pin from sliding or being pulled out of the
channels.
Standing horizontally on a surface
To place an FS20 fixture standing horizontally on a stable, horizontal surface:
Install two FS20 Tilt Brackets on
the fixture as described in
‘Mounting brackets’ on page 15.
Loosen the handwheels on the
brackets, adjust the brackets to
a suitable angle as shown in
Figure 6 and tighten the
handwheels.
Place the fixture on the surface.
Make sure that it is safe and
secure, and that it will not
present a danger of tripping or
falling.
For instructions on installing an FS20
fixture standing vertically on a horizontal surface, see ‘Vertical installation standing on
a surface’ on page 21.
Figure 6. FS20 standing horizontally
A
B
Figure 5. Locking Pin