Supplied By www.heating spares.co Tel. 0161 620 6677
6
221648B
Lighting the Fire Front
CAUTION. If the glass panel or internal fire parts are damaged
do not light or use the fire front before replacement parts are
fitted.
The fire front is fitted with a flue blockage safety device which
will shut it down if there is a problem with the chimney. If the fire
front shuts down frequently, for no apparent reason the first
thing to be checked are the chimney and the air inlets into the
room. An additional cause could be that the filter, in the gas tap
has become blocked.
Push the control knob fully in and turn it anticlockwise to “1
“
ignition, clicking of the ignition will be heard and the burner will
light.
IMPORTANT. If the burner does not light within three seconds,
release the control knob, wait ten seconds and repeat the
lighting operation.
Keep the knob pushed in for ten seconds, during which time the
ignition system will continue to operate, indicated by the clicking.
Air may be present in the supply to the fire front so that the initial
lighting operation may need to be repeated.
To change settings:-
Push in and turn. Refer to diagram 5.
If the burner goes out for any reason whilst the fire is turned on,
turn off.
Wait three minutes before relighting as above.
If relighting for any other reason wait two minutes before doing
so.
It can take several minutes for the fuel effect pieces to glow and
the flame effect to appear.
To turn off, turn the tap fully clockwise to “O” position and
release.
If there is a visible build up of soot on the fuel effect pieces follow
the instructions in Section on “Cleaning the Fire”.
Lighting the Fire Front with a Match or Spill
This is a temporary measure, to be used only in the event of the
failure of the battery or the spark generator.
Make sure that the fire front is cold before starting.
Remove the front casting, see diagram 5.6.
Hold a lighted spill or long match and position it so that the flame
is over the burner, see diagram 6.
Keep the spill in position, push in and turn the gas tap to position
“1.
“ ignition and the burner will light. Keep the knob pushed
for about ten seconds and the burner will stay alight.
If the burner should go out repeat the above, but now keep the
knob pushed in for a little longer.
Once lit operate the control knob normally.
This is a temporary measure only and the battery should be
replaced or the ignition system be repaired as soon as possible.
Cleaning your Fire
WARNING. This appliance contains metal parts (components)
and care should be taken when handling and cleaning, with
particular regard to edges.
Any cleaning work must only be carried out when the fire front
is cold.
Under normal circumstances dusting should be enough. An
occasional wipe over with a damp cloth will help remove marks.
Do not use an abrasive cleaning powder or liquid.
Instructions for Use
Diagram 5
APPLIANCE OFF
IGNITION POSITION
AND CENTRE
SECTION
FLAME EFFECT
CENTRE SECTION
FLAME EFFECT
WITH OUTER
SECTIONS
FUELBED GLOW
CENTRE AND
OUTER SECTIONS
FLAME EFFECT
WITH FUELBED
GLOW
FULL FLAME
EFFECT WITH
FUELBED GLOW
7581
