Glomex DANUBE NEO R500N, Руководство пользователя и инструкция по установке

Страница: 75 / 146

73
www.glomex.it
DANUBE “NEO”
(R500N - R500N/DCSS)
ENGLISH
If the connection between the App and control unit
is successful, the status LED on the control unit
becomes red, whereas the App control panel is like
shown in
Fig. 27 (the connection status will be
green).
If the connection between the App and control unit
is not successful, the control unit status LED
continues blinking with the green light, whereas the
App control panel is like shown in
Fig. 28 (the
connection status is red) and the message “Control
unit not connected” will appear for a few seconds.
This problem may occur for two reasons:
1) the mobile devices is too far from the control
unit. Move closer to the control unit and repeat the
procedure to connect to the antenna’s Bluetooth
signal.
2) the mobile device being used for connecting is
not the last one to have connected to the control
unit. Repeat the coupling procedure described in
paragraphs 8.1 and 8.2.
8.3 CONTROL PANEL
With the App and control unit connected, the App
control panel shows: the connection status (green
light); the “Disconnection” button on the top right to
disconnect the App from the control unit; the SAT
1, SAT 2 and SAT 3 buttons on the knob to change
the satellite selected to use as an alternative to the
physical selector located on the control unit (
Fig.
27 ).
Buttons “SAT1”, “SAT2”, “SAT3” under the knob are
used to read the information about the Satellite
stored in the 3 positions. The satellite name only is
displayed by default. Switch to Advanced Mode
(
App section for installers only ).
Fig. 27
Fig. 28