Glomex DANUBE NEO R500N, Руководство пользователя и инструкция по установке, Страница: 67 / 146

65
www.glomex.it
DANUBE “NEO”
(R500N - R500N/DCSS)
ENGLISH
S
WARNING
Pay attention not to bend the coaxial cables at a
right angle; the bending angle must always be
higher than 120°.
NOTA: Do not cut the connectors of the coaxial
cables (the operation would not be guaranteed any
more) and always use the original GLOMEX cables
supplied, even with inappropriate dimensions (too
long). In case a longer cable is needed, ask the
authorized retailer for a 10 m coaxial cable,
provided on demand. Do not use different cables,
as it would jeopardize the operation of the
equipment.
5. Close the control unit by tightening the screws
in the rear cover.
6. The control unit can be built- off-the-shelf plates
(3-module) or the GLOMEX accessory (code
4.010.0432, see
Fig. 19 ) by boring a hole with a
reciprocating saw and using the drill with 2.5
mm bit (use the cutting template on the
following page for the correct dimensions).
7. Connect the 1.5 m coaxial cable to the LNB IN
socket of the satellite receiver (not supplied).
Fig. 18
NO
NO