Glomex DANUBE NEO R500N, Руководство пользователя и инструкция по установке

Страница: 65 / 146

63
www.glomex.it
DANUBE “NEO”
(R500N - R500N/DCSS)
ENGLISH
7. Mount the coaxial cable onto the antenna:
- make sure that the cable core is correctly
inserted in the central hole of the female
connector on the antenna (otherwise, there
would be a short circuit and the fuse installed
on the power supply line inside the control
unit would trip, see page 90 for fuse
replacement);
- manually screw in the ring nut of connector F;
- once the ring nut has been manually screwed
in, tighten by ¼ turn by means of a 11 mm
wrench;
- insert the protection;
- make the coaxial cable pass through the
previously bored 12 mm hole on the vehicle
roof.
NOTA: For the connection of the antenna
coaxial cable, it is not necessary to remove the
dome!
8. Insulate with appropriate sealants the holes
drilled in order to prevent the passage of water.
S
WARNING
For a correct assembly, respect the installation
direction indicated in
Fig. 10 .
A different installation from the recommended one
could cause an incorrect operation of the antenna
due to the risk of water penetration into the
radome.
Operations to be carried out inside the vehicle.
1. Determine the correct position for the control
unit:
- it must be positioned near the satellite
receiver, as the provided coaxial cable is 1.5
m long;
- it must be reached by the power supply
cables coming directly from the battery ;
- it must be reached by the coaxial cable
coming from the antenna (10 m long);
- it must be located in a dry and ventilated area.
S
WARNING
Should it be necessary to shorten the cable, please
refer to the instructions given in Fig. 16.
Central hole of
female connector
Fig. 14
Central cable
conductor
Fig. 15