Assembly manual
Black Snapper L PRO
Seite
11
von
16
Installation of the booms and closing the frame
The boom pipe should end exactly at the edge of the
inner snapping part. When you adjust the vertical
alignment of the motor axis, please turn the boom first
until the cable holes are facing the ESCs. Make sure that
the hole doesn’t point upwards or downwards and that
the cables can’t get squeezed.
After this, mount the landing gear and adjust the motor
alignment using a 90° angled tool.
Before you fit the top frame plate on the side walls,
make sure that the side walls fit snugly into the bottom
plate and that no wires are squeezed. This process
requires a bit patience.
Battery plate with H3-3D gimbal, GPS holder and battery plate extension for lightweight batteries
(optional)
Please mount the snapping
parts and joints using the
following parts: 1 screw, 1
nut and 2 washers. The
washers have to be placed
on the outside of the
frame.
